When someone asks me why you would need a 3D printer, I show them this adapter. There was no way to use my Haida filter holder with 100 mm filters on my NIKKOR Z 14-24 mm f/2.8 S. So I designed an adapter. It sits on the lens in place of the hood, holds two stacked filters and doesn’t vignette.

As far as I know, the existing options for this lens rely on a larger filter system with 150 mm filters. For me that is too big and too much effort. The adapter was meant as a quick win, and that is what it turned out to be.
Small filters, wide lens
I use the filters for long exposures, for example at waterfalls. The Haida set is small and weighs almost nothing, so it is often in my travel backpack. With the adapter I can keep using it, now on the new wide-angle lens as well. I don’t have to carry a second, large system.
How the adapter holds
The adapter uses the bayonet where the lens hood normally sits. Small locking bars add enough friction so it doesn’t come off by itself. The front edge is beveled. That keeps it out of the frame even at 14 mm, tested with two stacked filters in the original Haida holder.

The file on MakerWorld is version 4. I printed it in PETG. For outdoor use I recommend PETG or ABS.
95 percent good, and that’s enough
The adapter isn’t perfect. I would say it works 95 percent of the way: it fits and does exactly what it should, but it isn’t quite as neat as the original screw-in filters. And the material isn’t the sturdiest. If it breaks, I print a new one for a few cents. In return the big filter system stays at home, and my small filters fit the new lens too. I’m very happy with that.