Tech / 3D Printing

Tea Rack for the 60 cm IKEA METOD Apothecary Cabinet

A printed rack for the large IKEA apothecary pull-out: up to twelve kinds of tea at a glance, taken out from below, with lids that keep the dust off.

5 Apr 2026, updated 18 Nov 2026
View on MakerWorld

I like tea, and with a few kinds a drawer gets messy fast. So my IKEA apothecary cabinet holds a printed tea rack. Every kind is visible from the front, and you take the bags out from below. The basic setup holds twelve kinds.

White printed tea rack with compartments holding tea bags of different kinds
Every kind of tea is readable from the front.

It is built for the METOD apothecary cabinet that measures 30 × 60 cm (article number 592.875.28). The files are free on MakerWorld.

Base plate, compartments, lids

The base plate levels out the slanted walls of the pull-out and gives the rack a straight footing. The compartments stack on top of it. They come in two heights, 10 and 10.5 cm, because the cabinets aren’t all the same height inside. So measure inside before printing. Lids close the top and keep the dust out.

Tea rack in the open IKEA apothecary pull-out, two compartments stacked with tea packs
The rack is sized exactly for the pull-out.

For the rack, the rods that extend the pull-out frame have to come out. If they are already installed, the inserts cover the screw holes. The same goes for my spice inserts in the narrow 20 cm apothecary cabinet.

Work in progress